INSTRUCTIONS
How to attach your Hookaholic Shisha parts:
- Attach the nose and hose end to the hose, then attach this to the box.
- Place 3 AAA batteries into light and press it in under the box. (however, you can still use it without this step)
- Fill the Urban Shisha via the larger round hole on the top with 250mls of water, this should be just under half way.
- Press silicon head into place.
- Put flavour around the edges of the silicon head and fluff with the metal sick on the tongs provided. Do not put flavour in the centre.
- Place metal coal tray in silicon head.
- Place two coals into metal tray and put wind cover on the top.
- Wait up to 3-5 minutes for metal tray to heat up before you experience a lot of smoke.
- Enjoy!
Please read the following before using your Hookaholic:
- Do not blow hard into the hose as water will go up into the head, wet the tabacco and will not smoke.
- To release air, take the silicon flap off and put it back on to make sure it is not stuck. Then blow very gently into the hose.
- Do not over fill with water. Check water level is just under half way.
- The shisha needs at least 2 coals to make the metal plate hot enough to produce smoke.
- When starting the shisha close wind cover to keep the heat from the coal in. Only open wind cover once started or adjust to your preference.
After care:
- Discard remaining flavour from head and rinse with water.
- Put soapy water inside shisha and swish around then rinse thoroughly.
- Rinse inside hose when needed.